|
4. Drill a ¼ inch hole 1 inch deep through the tile.
5. Insert plastic anchor (included) into the hole and tap into the wall gently with the hammer. Screw rail into position and level rail. Mark all other flange holes.
6. Remove rail, and repeat steps # 3 and 4 to all marked flange holes.
7. Using stainless steel screws (included), attach rail on to wall firmly but gently. Screws should be tight, but be careful not to over tighten them. One can take screw heads off if to energetic or crack the tile.
8. After rail is in place, use a towel to wipe off the rail. Place caulking around flange ends to seal and prevent water from getting behind flanges. This step also will give your rail a professional finished look. Wipe excess caulking from rail flange and wall.
9. To maintain you beautiful rail, just wipe down after shower is used.
10. Enjoy your new SAF-T-RAIL
|
