Measuring for Correct Size
Grab Bar Dimensions and Specifications
All SAF-T-RAIL grab bars are drawn and manufactured according to outside to outside dimensions unless otherwise noted. This makes ordering your hand rails easy to do, to obtain the correct size for your bathroom. To figure the total length of the bar required, just measure the total length you need. Its as easy as that! Grab bars can be custom made to your specifications in various sizes, lengths and configurations. Please be aware, that all custom size rails do require 3 to 4 weeks for delivery.
Using the diagram below measures as follows:
Three way grab bar:
- Specifications:
- = the last vertical flange or end of the rail
- = the flange near the vertical bend at the wall
- = the flange near the horizontal bend to vertical rail
- = top horizontal flange.
- Measure A to the bend of the rail before the B flange on the vertical side
- Measure from the bend of the elbow on the vertical side to the corner wall
- Measure from the corner to the length you want the rail to end
- Example of measuring of the picture below
- 24 inches on right side of diagram (D to elbow, near C)
- 24 inches from the bend to the wall ( Elbow to wall)
- 24 inches on the wall (corner to ending dimension)
- This is a 24 x 24 x 24 grab bar
|
A C |
NOTE: The left Handed grab bar is measured the same way,
except the horizontal rail with the “D” flange is on the left side of the rail.
One Wall Mount Rail:
Specifications:
- = top out side flange on long rail
- = the flange near the bend of the rail
- = the flange on the outside of the short rail
WALL TO FLOOR
Requires a Core Drill to install with a 1 1/2 inch drill bit for stud placement
Specifications: Shown is a 30x30 with a 3 inch stud
- = Height from the floor to bend
- = Width from bend to wall
| Floor A |
 |
